Air, Carbon and Suspension Geometry

Overview

Power gets a hypercar to the next corner. Structure and air decide what happens once it arrives. The cars on our board split into two camps: those shaped to slip through the air at extreme speed, and those shaped to press themselves into the road. A few try to do both by changing shape on the move, which brings its own weight and complexity.

Structure

The carbon tub is the car

Every car on the board is built around a carbon-fibre monocoque: a single stiff shell that carries the occupants and anchors the suspension. McLaren calls the W1's version the Aerocell and fixes the seats into it, so the driver adjusts the pedals and steering wheel instead. Pagani weaves titanium threads into carbon fibre for its Carbo-Titanium material, which it says resists splintering better than carbon alone. Rimac bonds the Nevera's battery structure to its tub so the heaviest part of the car also adds stiffness.

A stiff tub lets engineers soften springs without losing precision, because the suspension, not the body, does the moving.

Downforce

Ground effect versus wings

A wing makes downforce by deflecting air, and it always adds drag. A shaped underfloor makes downforce by speeding air beneath the car, and does so with less drag for each kilogram of load. The Valkyrie is the clearest case: Adrian Newey's team shaped the car around two large venturi tunnels running under the cabin, so the body above is almost secondary.

The McLaren W1 combines both. Its floor works in ground effect, and its Active Long Tail rear wing extends up to 300 mm rearward. In Race mode the car lowers itself and McLaren quotes up to 1,000 kg of downforce.

Drag

Long tails and smooth bodies

For top speed, the job reverses. The Chiron Super Sport's body is 25 cm longer than a standard Chiron's, letting air leave the car more cleanly and reducing drag at the rear. Koenigsegg's Jesko Absolut drops the big wing of the Attack in favour of two rear fins, and Koenigsegg quotes a drag coefficient of 0.278. Remember that drag depends on frontal area as well as the coefficient, so a wide car with a low figure is not automatically slippery.

One car, two shapes

Attack and Absolut

The Jesko shows how far one platform can be pulled. The Attack carries a large wing on swan-neck mounts and a deeper front splitter for circuit work. The Absolut shares the engine and tub but trades almost all of that downforce for low drag. Buyers chose one shape at order. The split is honest about physics: no single fixed body is ideal for both a lap of Spa and a run on a closed highway.

Suspension

Holding the platform steady

Aerodynamic loads only work if the car's ride height stays controlled. Koenigsegg uses its Triplex arrangement, a third horizontal damper linking the rear wheels, to resist squat under hard acceleration. McLaren's W1 uses a hydraulically linked active system that can drop the body in Race mode and stiffen it against pitch. The Nevera relies on double wishbones and electronically controlled dampers, with torque vectoring doing part of the work a stiffer anti-roll setup would do in a lighter car.

Reading the numbers

What downforce figures leave out

Makers quote downforce at different speeds, and some quote a peak in a track mode that the road car never uses. Downforce rises with the square of speed, so 1,000 kg at 280 km/h is roughly a quarter of that at 140 km/h. Look for the speed attached to any figure, and for the mode the car was in.

Next

How buyers win a build slot

Allocation →
Back

How the power gets made

Power →